![]() ![]() The ntpdate command will let you manually check your connection configuration with the NTP-server. Let us now configure our Debian like client machine to be time synchronized with the NTP server. Note that standard the Raspberry Pi OS does not come with a Firewall! NTP Client Run the following command as sudo to open port 123 for incoming traffic: sudo ufw allow from any to any port 123 proto udp Step 6: Configure Firewall so that client(s) can access NTP serverįinally, it is time to configure your system’s UFW firewall that incoming connections can access the NTP server at UDP Port number 123. The Active status verifies that your NTP server is up and running. Lets check if NTP is up and running, we use the same command as above with a small adjustment. ![]() You can replace these with the pool’s you like.Įxit the file by hitting Ctrl+X and then press y for saving changes.Īfter making an adjustment or change to any config file it’s recommended to reboot the service or program We have highlighted this list in the above image. In this file, you will be able to see a pool list. Open the file in the nano editor as sudo by running this following command: sudo nano /etc/ntp.conf This includes making some changes in the /etc/ntp. However, you can switch the server pool to the ones closest to your location. The NTP server is mostly configured to fet the proper time after initial installation.
0 Comments
Leave a Reply. |